Barb to AN Flare Adapters
Part numbers: AF741-06-05
LESS THAN 1/2 PRICE!! ONLY 3 LEFT AT THIS PRICE!
No welding… no clamps… no hassle with this unique O-ring design. This revolutionary fitting allows you to convert any barb, plastic or metal, over to the ever-popular range of AN style fittings in our inventory. Sizes range from 5/16" to 3/4" Barb. Which accommodates a variety of electrical, oil, and fuel pumps.
Instructions:
1. Undo the fitting and lay it out. Then slide the base of the fitting over the barb.
2. Lube up the O-ring thoroughly with an appropriate lubricant. Carefully not to tear, slide the O-ring over the barb’s edges. The O-ring must seat against the lowest barb edge.
3. Whilst holding the bottom half of the fitting to ensure the O-ring does not move from its seated position. Slide the top half over the barb and tighten.
Note:
Do not over tighten! Only a snug fit is required till the fitting does not slide up or down.
Tip:
Submerging the O-ring in hot water for a few minutes before assembly can make it easier to slide over the barb without tearing the O-ring.